Home

APS
Downloads
Buy APS

Support
Register
Contact us

Knowledge Base of APS

Subscribe to the GEPList
 
Visit GEP

 

Settings and Features

Training Set Tab
 
The Training Set Tab gives access to the following settings and features:

Samples
Allows you to select a subset of samples for training.

Independent Variables
This box is informative only and shows the number of independent variables in the training set.

Reset
Reverts to the total number of training samples in your data.

Refresh
Refreshes the panel after changing the training data set.

Change Data Set
Allows you to choose another training set for modeling.

Distribution
Allows you to visualize the distribution of values for each variable in the training set. This plot shows a maximum of 250 points at a time and, therefore, for datasets with more than 250 samples you must move the scroll bar on the right of the table and APS will redraw the plot starting at the first visible row. Then, by placing the cursor over the plot, APS shows you the range used to draw the plot. 

Scatter
Allows you to visualize the scatter plot of each independent variable in the training set against the dependent variable. This plot shows a maximum of 250 points at a time and, therefore, for datasets with more than 250 samples you must move the scroll bar on the right of the table and APS will redraw the plot starting at the first visible row. Then, by placing the cursor over the plot, APS shows you the range used to draw the plot.

Home | Contents | Previous | Next